ACX Audio Requirements: The Complete Checklist
ACX's audio submission requirements are short, but they are enforced by an automated QA pass before any human listens. Most books that get bounced fail on one of the measurable numbers below — not on the narration. This page lists every requirement, the exact target, and the practical fix when a chapter misses it.
To run these checks against your own files, use the free ACX compliance checker — it measures RMS, peaks, noise floor, room tone, and MP3 format in your browser without uploading anything.
The requirements at a glance
| # | Requirement | ACX target | First fix to try |
|---|---|---|---|
| 1 | Loudness | −23 to −18 dB RMS | Normalize toward −20.5 dB, then re-limit |
| 2 | Peaks | No peak above −3 dB | Limiter with a ceiling near −3.5 dB |
| 3 | Noise floor | −60 dB RMS or lower | Denoise, or record in a quieter room |
| 4 | Spacing | Room tone at head and tail, max 5 s each | 0.5–1 s head, 1–5 s tail of real room tone |
| 5 | Format | MP3, 192 kbps+, CBR, 44.1 kHz | Re-export from the WAV/FLAC source |
| 6 | Channels | All-mono or all-stereo book | Mono is the spoken-audio standard |
| 7 | File limits | ≤120 minutes, ≤170 MB per file | Split long chapters |
| 8 | Content | Opening/closing credits, headers read aloud, 1–5 min retail sample | Record and include them |
1. Loudness: −23 to −18 dB RMS
ACX measures the RMS (average) loudness of each file. Quiet chapters feel thin; loud chapters clip. The measurement is taken over the whole file, so a single loud passage can pull a quiet chapter into range on paper while it still sounds uneven — which is why ACX also reviews consistency across the book.
Fix: normalize the body of the narration toward −20.5 dB RMS, keep peaks under control with a limiter, and use the same settings for every chapter. If one file sits at −26 dB, do not just add gain — limit the peaks first, then bring the level up so the peaks stay under −3 dB.
2. Peaks: no higher than −3 dB
The loudest moment in each file must stay below −3 dB. This leaves headroom so nothing distorts on playback. Sibilance, plosives, and excited reads are the usual offenders.
Fix: a look-ahead limiter with its ceiling set just under −3 dB. Lowering the whole file's gain also lowers peaks, but it drags the RMS down with it, so limit first, then normalize.
3. Noise floor: −60 dB RMS or lower
The noise floor is the level of the room when nobody is speaking: HVAC, fans, traffic, reverb tails. ACX measures it from the room tone in your files and rejects anything above −60 dB RMS. One noisy chapter is enough to send the whole book back.
Fix: treat the room (soft furnishings, away from vents), then use spectral noise reduction sparingly — heavy-handed denoising leaves artifacts ACX's reviewers hear. Record 30–60 seconds of clean room tone at the start of every session; you will need it for spacing anyway.
4. Spacing: room tone at the head and tail
Every file must open and close with real room tone. ACX's current limit is no more than 5 seconds at each end. The long-standing practice — and what most producers aim for — is 0.5 to 1 second at the head and 1 to 5 seconds at the tail, with roughly 2.5 to 3.5 seconds a common sweet spot for the ending.
Two ways to fail here: cutting the file so tight the narration starts at sample one, and padding with digital silence instead of room tone. ACX rejects dead silence; it must be the actual sound of your room.
Fix: paste room tone from the same session at the head and tail, then fade in and out gently.
5. Format: MP3, 192 kbps or higher, CBR, 44.1 kHz
Uploads must be MP3, encoded at 192 kbps or higher at a constant bit rate, sampled at 44.1 kHz. A 320 kbps VBR export fails on the variable bitrate. Re-encoding a 128 kbps MP3 at a higher rate does not fix anything — the quality loss is already in the file.
Fix: go back to the original WAV or FLAC source and export MP3 CBR 192 kbps (or 320 CBR), 44.1 kHz.
6. Channels: consistent mono or stereo
A book must be entirely mono or entirely stereo. Mono is the standard for spoken audio and the safest choice.
Fix: if a few chapters were recorded in stereo, convert the whole book to mono so every file matches.
7. File limits: 120 minutes and 170 MB
No single file may run longer than 120 minutes or weigh more than 170 MB. At 192 kbps CBR, 170 MB is roughly two hours, so most violations come from marathon recording sessions left unsplit.
Fix: split at a scene or section boundary, and keep the spacing rule in mind for the new head and tail.
8. Content ACX listens for
The automated pass measures numbers, but a human reviewer also checks that the opening and closing credits are present, every section header is read aloud, and a retail sample between one and five minutes exists as its own file. None of these can be verified from the waveform — keep a proofing checklist for them.
What the requirements do not cover
Clean audio that meets every number can still be rejected for mouth clicks, plosives, misreads, repeated lines, or pacing problems. Listen through the full book before submission; the checklist above gets you past the automated gate, not past the reviewer.
Check your files against this list
The free ACX compliance checker measures requirements 1–7 in your browser, file by file, with nothing uploaded. When a whole book needs repair — denoising, loudness normalization, limiting, room tone padding, and re-export as compliant MP3s — the NarratorOps workbench does it in one pass and re-measures the exports automatically.